 |
AES Price: |
|
AES Price: |
Data
Sheet (42kb) |
|
AES Catalog Instructions and Ordering Information
[ Home
| the New
Store! ]
[ Wave! Central |
News
& Info | Contact
AES ]
This probe allows for accurate triggering of scope display from spark plug wire signals. You can organize your display by triggering from #1 plug wire. It can be used in an external trigger jack or via a signal channel.
This is the second generation trigger pickup from AES, now with improved circuitry. We have pickups available for digital scopes as well as analog scopes.
Available for all popular scopes:
| If your scope is ... | You need this AES Trigger Pickup ... |
| Analog Scope with BNC inputs | AES# 01-14-A Use with most analog scopes that have at least 1 meg input impedence. (Pictured above.) AES Price: $38.50 |
| Digital Scope with BNC inputs -- Fluke 90-series scopes, OTC Vision | AES# 01-14-D Pictured above. AES Price: $53.00 |
| ADL 7100, ET-2020, KAL 575, and LS-2000 | AES# 01-14-LS AES Price: $53.00 |
| OTC Perception | AES# 01-14-PER
AES Price: $53.00 |
Use the AES Trigger Pickup to sync the display of an ignition signal. For example, many crankshaft sensors have cylinder ID signals.
It can be difficult if not impossible to stabilize this signal. Since it is in sync with the plug signals, use the trigger pickup on plug #1 to stabilize.
Installation:
Install the AES Trigger Pickup into the desired channel of your scope (see below).
Install the Trigger to the desired spark plug with the indicator marks towards the plug.
Scope Adjustment:
For scopes with External Trigger Jack -- Set LEVEL to at least 2 volts.
Set SCOPE to positive. Set SOURCE to external.
For the Fluke 97 -- set the LEVEL to 2 volts.
For the LS-2000 -- install this lead into channel #1.
For scopes without External Trigger Jack -- Even with scopes that have an
external jack, it is a good idea to use a regular channel as the trigger source. This
helps to insure accuracy since you can see the signal and visually set the trigger level.
Set VOLT/DIV to 2. Start with a TIME/DIV of 5 mS and adjust as needed. Make
sure the SOURCE for the trigger is set to the channel this lead is connected to.
Set SLOPE to positive and set the LEVEL to at least 2 volts, or as needed.
[ Home
| the New
Store! ]
[ Wave! Central |
News
& Info | Contact
AES ]
Snap-on and Vantage are registered trademarks of Snap-on
Incorporated.
These trademarks and companies are not associated with AES.
Still
Can't Find it?
Thousands of products listed at Universal Tools!
Hand tools, Body tools, Shop equipment, Air
tools, etc...
Information in this document is subject to change without
notice.
AES Wave! is a claimed trademark of Automotive Electronics Services, Inc.
Other products and companies referred to herein are trademarks or registered trademarks of
their respective companies or mark holders and are not associated with AES.
AESsupport@aeswave.com
Copyright © 1995-2004 Automotive Electronics Services, Inc.
All rights reserved.
Revised: April 06, 2004.
