Shop by Price
Featured Products
Join our Newsletter
Subtotal: $0.00

> Emissions > IMready Emissions Pre-Tester - Programmable for Gas and Diesel

IMready Programmable Pre-Tester
Pre test runs in seconds
Translucent housing glows with LEDs

IMready Emissions Pre-Tester - Programmable for Gas and Diesel

California Residents: Proposition 65 Warning
Eligible for FREE Ground Shipping(Eligible for FREE Ground Shipping)
Bundled Products

Help your customers know when their car is ready to return for their follow-up emissions test with the IMready, a low-cost OBDII IM Readiness Monitoring Tool for the California emissions test.

Eliminate the cost and aggravation of your customer’s failed emissions test, use the IMReady Pre Tester to check monitor status before performing the California BAR-OIS test on Gas and Diesel vehicles.

Runs in seconds. A yellow or red light means the car isn’t ready to pass. Connect the IMready to the OBD2 port on the vehicle and, with KOER, the pre test will run. The transluscent case aids in reading LED status from any angle.
Three LEDs indicate the result of the pretest:
Green:  All monitors finished and there are no DTCs. The vehicle should pass the OBD portion of emissions testing.
Red:  There is a problem with car and the vehicle will most likely not pass.
Yellow: The drive cycle is not yet complete or the mointors are not yet ready. The vehicle probably will not pass. 
Failed emissions tests are very expensive (financially and emotionally) for customers. End the guesswork and put your customer's at ease with a pre test before running the official emissions test. When a long line of customers are waiting to get their vehicles tested use the IMready to keep them engaged, to build customer loyalty and goodwill for your shop.
What's worse is when a customer fails the official emissions test, has repairs done, and then fails the test a second time. Use the IMready to let the customer know when to get retested. Sell, rent or loan an IMready to customers after their vehicle as been repaired and let the customer drive the vehicle with the IMready until the LED turns green.
The IMready is designed with a low power/standby mode so it can safely stay installed on the vehicle, even when the vehicle is not running. It can take from 5-100 miles for the lights to turn from yellow to green or red.
Can be programmed for with 4 different configurations to cover California model year (96-current), fuel (gas/diesel/hybrid), and monitor status (All ready, up to 2 not ready, 1 not ready, EVAP not ready)
IMready Programmable Pre-Tester + IMclean Wireless DAD for California BAR-OIS
Buy IMclean DAD Bluetooth for California BAR-OIS and get IMready Emissions Pre-Tester - Programmable for Gas and Diesel at an additional 100% off our everyday low price.
Regular Price: $1,554.95
Combo Price: $1,495.00
This Item: IMready Emissions Pre-Tester - Programmable for Gas and Diesel
IMclean DAD Bluetooth for California BAR-OIS

Supporting our community

Banner Diagnostic Network Banner Assurance iATN We are a Proud Friend of the NACAT Education Foundation ASE AESwave Ascca AESwave KivaAESwave IAP