Categories
Shop by Price
Vendors
Join our Newsletter
Subtotal: $0.00

> Lab Scopes Accessories > Test Drive Test Leads for the Snap-on MODIS

 
 

Test Drive Test Leads for the Snap-on MODIS

AES#:
03-760-Modis
 
$129.00
Qty:
 
California Residents: Proposition 65 Warning
 
 
 
Eligible for FREE Ground Shipping(Eligible for FREE Ground Shipping)
Description
More Info

Clean it up with AES' ST3 Test Lead Kit!

The MODIS is great tool but it's lab scope test leads are too short for test drives. Plus, when using multiple channels ground stacking becomes a problem. The ST3 Test Lead Kit for Snap-on MODIS solves these problems.

 

Eliminate Ground Stacking Problems
Ground stacking becomes an issue when using more than one channel, and a potential danger when all four channels are utilized. The ST3 Test Lead Kit for Snap-on MODIS includes a Ground Pigtail to organize multiple grounds from test leads and amp probes, etc... when using multiple channels.


Take your MODIS on test drives!
The ST3 Test Lead Kit for Snap-on MODIS contains 4 test leads that are shielded tip-to-tip and 10-ft long: long enough to reach from the engine compartment and into the back seat if needed.


Keep it safe and make it mobile!Keep your MODIS on the cart!
Set up a station for the MODIS and keep it there. Eliminate the worry of balancing it under the hood of the car or on a fender.

In addition, with the lead set still hooked up, you have enough cable to put the MODIS right inside the car when you to take it for a test drive.


Contents
Set of 4 test leads, one ground pigtail, and 3 ground extensions.
* Yellow test lead: 10-ft long (Used for Channel 1)
* Green test lead: 10-ft long
* Blue test lead: 10-ft long
* Red test lead: 10-ft long
* Ground Pigtail: 5-1/2 inches long
* Three 3-ft Ground Extensions

 

Characteristics of the ST3 Test Drive Test Leads for the Snap-on MODIS  (AES# 03-760-MODIS):
Attentuation:   1:1
Connection at Scope:   Signal: 4mm shrouded, stacking Banana-plug
  Ground: 4mm shrouded, stacking Banana-plug                            
Cable:   ST3, Shielded  
Color:   Yellow, Green, Blue, Red
Length:   10-ft
Connection at vehicle:    Signal: 4mm shrouded Banana-plug
  Ground: 4mm shrouded, stacking Banana-plug

 

 

 

 

Overall View

 
 

View of Grounds

Shows the 4 ground inputs stacking off the "pigtail" rather than the scope chasis.

 

 
 

View of Front

The pigtail is on the left and wraps down to receive the grounds from each of the test leads.

 

 
 

Rear View

Each test lead has two connections into the scope:
1. Signal (for channel 1 thru 4)
2. Ground
The Ground Pigtail allows all 4 leads to be used at the same time while keeping the grounds organized.

 

 
 

Work Station

 

 
 

 

 

 
 

 

 

 
 



 

 

 

 

Supporting our community

Banner Diagnostic Network Banner Assurance iATN We are a Proud Friend of the NACAT Education Foundation ASE AESwave Ascca AESwave KivaAESwave